RESUMO
Recently, diesel engine emissions have been designated as a first-class carcinogen by the World Health Organization (WHO). As such, problems with diesel engine emissions continue to increase around the world. This study aimed to analyze the emissions (CO, NOx, PM) of agricultural tractors during farming operations in order to build a reliable national inventory of air pollutant emissions. Emission data were collected using a portable emission measurement system during actual agricultural operation. The load factor (LF) of the engine was calculated using the collected engine information, the emission factor was analyzed using the LF and the measured emission. The LF was significantly different from the current standard value of 0.48, which is used in Korea to calculate exhaust emissions. The deviation ratio of the emission factor was 0.039 ~ 56.59 compared to Tier-4 emission regulation standards. Under many conditions, the calculated emission factor was higher than the emission limit. Thus, this study provides useful information for emission inventory construction through emission calculation under actual conditions and suggests the need to realize the currently applied emission factor.
RESUMO
The purpose of this study was to analyze the tillage depth effect on the tractor-moldboard plow systems in various soil environments and tillage depths using a field load measurement system. A field load measurement system can measure the engine load, draft force, travel speed, wheel axle load, and tillage depth in real-time. In addition, measurement tests of soil properties in the soil layer were preceded to analyze the effect of field environments. The presented results show that moldboard plow at the same tillage depth had a wide range of influences on the tractor's working load and performance under various environments. As the draft force due to soil-tool interaction occurred in the range of 5.6-17.7 kN depending on the field environment, the overall mean engine torque and rear axle torque were up to 2.14 times and 1.67 times higher in hard and clayey soil, respectively, than in soft soil environments. In addition, the results showed tractive efficiency of 0.56-0.73 and were analyzed to have a lugging ability of 67.8% with a 44% maximum torque rise. The engine power requirement in hardpan was similar within 3.6-9.6%, but the power demand of the rear axle differed by up to 18.4%.
Assuntos
Agricultura , Solo , Agricultura/métodosRESUMO
This study aims to design, develop, and evaluate the traction performance of an electric all-wheel-drive (AWD) tractor based on the power transmission and electric systems. The power transmission system includes the electric motor, helical gear reducer, planetary gear reducer, and tires. The electric system consists of a battery pack and charging system. An engine-generator and charger are installed to supply electric energy in emergency situations. The load measurement system consists of analog (current) and digital (battery voltage and rotational speed of the electric motor) components using a controller area network (CAN) bus. A traction test of the electric AWD tractor was performed towing a test vehicle. The output torques of the tractor motors during the traction test were calculated using the current and torque curves provided by the motor manufacturer. The agricultural work performance is verified by comparing the torque and rpm (T-N) curve of the motor with the reduction ratio applied. The traction is calculated using torque and specifications of the wheel, and traction performance is evaluated using tractive efficiency (TE) and dynamic ratio (DR). The results suggest a direction for the improvement of the electric drive system in agricultural research by comparison with the conventional tractor through the analysis of the agricultural performance and traction performance of the electric AWD tractor.
